# Six Dogs Physical Console — Build Specification This is an **optional low-voltage, user-operated indicator**, not a physiological sensor, diagnostic device, surveillance product, or medical stress treatment. Example firmware has been written but **not compiled or flashed on real hardware in this release**. ## Hardware baseline: Arduino Uno-compatible 5 V board - 1 USB-powered Arduino Uno-compatible microcontroller with USB serial support - 6 low-voltage LEDs, each with its **own 220–330 Ω current-limiting resistor** - 1 momentary normally-open push button - Breadboard and insulated jumper wires, suitable USB data cable - **No** mains power, exposed high voltage, cameras, microphones, biometric electrodes, wireless tracking, children’s profiles, or external cloud services ### Wiring table | Dog | Pin | Physical indicator | |---|---|---| | 1. KNICK | D3 | LED 1 | | 2. KNACK | D4 | LED 2 | | 3. PADDY | D5 | LED 3 | | 4. WHACK | D6 | LED 4 | | 5. DOG | D7 | LED 5 | | 6. BONE | D8 | LED 6 | For each LED, connect its corresponding Uno output through a **220–330 Ω series resistor** to LED anode (+); cathode (−) goes to board GND. Connect a momentary button from D2 to GND. Firmware enables the internal INPUT_PULLUP. Do not connect a bare LED without its resistor. Connect board USB to a trusted, user-selected computer. Never wire this device to mains equipment or medical systems. ## Physical interactions - At power-on, LED 1 (KNICK) is on; the other five are off. - A debounced short button press advances to the next named step, wrapping BONE → KNICK. - A long press (≥ 1500 ms before release) resets to KNICK. - Current step is printed over USB serial; this device does **not** infer what anyone feels. ## Serial protocol version 1 Use **115200 baud**, 8N1, ASCII, LF-terminated commands. Browser sends a command only after explicit user action and browser permission. Commands accepted by firmware: SD1 STEP 1 SD1 STEP 2 SD1 STEP 3 SD1 STEP 4 SD1 STEP 5 SD1 STEP 6 SD1 RESET SD1 QUERY Examples of firmware responses: SD1 STATUS STEP=1 NAME=KNICK SD1 STATUS STEP=6 NAME=BONE SD1 ERROR INVALID_COMMAND The browser console may send current selected step through Web Serial, where available over a secure origin and explicitly approved by the user. Browser-side writing is implemented; parsing and independently verifying a physical status response is not. Use the direct LED status and a serial monitor for confirmation. ## Development / limitations - Firmware source: six_dogs_uno/six_dogs_uno.ino - Arduino IDE: select compatible Uno board and port, compile/upload on a trusted machine. - The board requires a manual user installation and wiring; neither the board nor the app is automatically deployed by GitHub. - Electrical behavior, device interoperability, access policy, enclosure design, EMC, durability, and accessibility have **not** been independently validated. - **WHACK** is a decisive **nonviolent** step name. Do not build striking, shock, restraint or coercive mechanisms into this controller.